Ricoh PRO C7200S - When You Cannot Make Clear Copies

Troubleshooting When You Use the Copy/
Document Server Function
This chapter describes likely causes of and possible solutions for Copier and Document Server function
problems.
When You Cannot Make Clear Copies
Problem Cause Solution
Copies appear dirty. Image density is too high. Adjust the image density settings. For
details about image density settings,
see "Adjusting Copy Image Density",
Basic Operations.
Copies appear dirty. Auto Image Density is not
selected.
On the control panel, select [Auto
Density].
The reverse side of an
original image is copied.
Image density is too high. Adjust the image density settings. For
details about image density settings,
see "Adjusting Copy Image Density",
Basic Operations.
The reverse side of an
original image is copied.
Auto Image Density is not
selected.
On the control panel, select [Auto
Density].
The reverse side of an
original image is copied.
The original is thin. On the control panel, select [Auto
Density], or adjust the image density
settings.
For details about image density
settings, see "Adjusting Copy Image
Density", Basic Operations.
Troubleshooting When You Use the Copy/Document Server Function
469