2. Trailing edge:
• When you use paper other than coated paper: 5.0 ± 1.0 mm (0.20 ± 0.04inches) (Paper Weight
1–Paper Weight 3), 4.0 ± 1.0 mm (0.16 ± 0.04 inches) (Paper Weight 4–Paper Weight 8)
• When you use coated paper: 7.0 ± 1.0 mm (0.28 ± 0.04 inches) (Paper Weight 2), 5.0 ± 1.0mm
(0.20 ± 0.04 inches) (Paper Weight 3), 4.0 ± 1.0 mm (0.16 ± 0.04 inches) (Paper Weight 4–
Paper Weight 8)
3. Left edge: 2.0 ± 1.5 mm (0.08 ± 0.06 inches)
4. Right edge: 2.0 ± 1.5 mm (0.08 ± 0.06 inches)
• The missing image area can be changed. For details, consult the administrator or contact your
service representative. If plain paper that weighs less than 70 g/m
2
or coated paper that weighs
less than 105 g/m
2
is registered as custom paper from the master library, the missing image area
for the leading edge is set to approximately 5 mm. Depending on the paper's condition, the reverse
side's missing image area and its registered values may be different.
Sizes Detectable with Auto Paper Select
The following sizes and orientations of originals are detected automatically:
(mainly Europe and Asia)
Original
location
A3 B4 JIS A4
B5 JIS
A5 A5
B6 JIS
Exposure
glass
*1 *1 *1, *2 *1 *1
×
*1,*3
×
ADF
*4
Original location 11 × 17 8
1
/
2
× 11 8
1
/
2
× 13
Exposure glass × ×
*2 *7
ADF
*5 *6 *7
: Detectable size, ×: Undetectable size
*1
If you want to switch the detectable sizes from these sizes to 8K and 16K, contact your service
representative.
*2
Default is A4. If you want to switch the detectable size from A4 to 8
1
/
2
× 11, contact your service
representative.
*3
If you want to make A5 size detectable, contact your service representative.
6. Paper Specifications and Adding Paper
164
To Next Page
Loading...
