to specify the size of the originals, see "Specifying Original Sizes", Basic Operations or page 402
"Specifying Scan Settings".
Originals that are difficult to detect the size
If the original type is one of the following, the machine might not detect its size correctly and the
receiver's machine might print it on paper of the wrong size. The machine may also fail to copy or print
the image on an appropriate size of paper.
If the original type is one of the following, select the paper size manually:
• Originals with indexes, tags, or other projecting parts
• Transparent originals such as transparencies or translucent paper
• Dark originals with a lot of text and drawings
• Originals which partially contain a solid image
• Originals which have solid images at their edges
• Originals with glossy surfaces
• Bound originals of more than 10 mm (0.4 inches) in thickness, such as books
Placing Originals on the Exposure Glass
• Keep your hands away from the hinges and exposure glass when lowering the ADF. Not doing
so may result in an injury if your hands or fingers are pinched.
• Do not lift the ADF forcefully. Otherwise, the cover of the ADF might open or be damaged.
1. Lift the ADF.
Be sure to lift the ADF by more than 30 degrees. Otherwise, the size of the original might not be
detected correctly.
2. Place the original face down on the exposure glass. The original should be aligned to the
rear left corner.
Start with the first page to be scanned.
6. Paper Specifications and Adding Paper
166
To Next Page
Loading...
