1. Positioning mark
3. Lower the ADF.
• When you place a thick book or three-dimensional original on the exposure glass and lower the
ADF, the back side of the ADF rises up to accommodate the original. Keep your hands away from
the hinges at the back of the ADF when you close it.
• Take care to place originals after any correction fluid and ink has completely dried. Not taking this
precaution could cause marks on the exposure glass that will be scanned.
• For details about how to specify the size of the originals, see "Specifying Original Sizes", Basic
Operations or page 402 "Specifying Scan Settings".
• For details about the sizes of originals that can be used, see page 161 "Recommended Original
Sizes and Weights".
Left original beeper
The beeper sounds and an error message is displayed when you leave your originals on the exposure
glass after scanning.
You can change the beeper setting under [Alert Sound: Original left on Exposure Glass] in the User
Tools menu. For details, see "General Features", Preparation.
Placing Originals
167
To Next Page
Loading...
