3. Carefully push the paper tray fully in.
• If you select Paper Weight 5 to 8, [Coated: Glossy], [Coated: Matte], [Coated: High Gloss], or
[Label Paper] in [Tray Paper Settings], air is blown out automatically to fan the paper loaded in the
three-tray wide LCT. Fan this paper before loading it. For details, see page 171 "Fanning the
paper".
• Various sizes of paper can be loaded in the three-tray wide LCT by adjusting the positions of side
fences and end fence. For details, see
page 193 "Changing the Paper Size in the Three-tray Wide
Large Capacity Tray".
• You can load envelopes in the three-tray wide LCT. When loading envelopes, place them in the
correct orientation. For details, see page 235 "Envelopes".
Loading Paper into the Two-tray Wide Large Capacity Tray
The two-tray wide LCT is identified as Tray 3, Tray 4, Tray 5, Tray 6, Tray 7, and Tray 8.
• Check the paper edges are aligned at the left side.
• When you use paper of Paper Weight 7 with a convex curl greater than 5 mm, or paper of Paper
Weight 8 with a convex curl greater than 3 mm, a paper jam may occur if the height of the stacked
paper is less than 4 mm. To use paper in such condition, set the paper in the tray as follows:
• Set as many as 5 to 10 more sheets than the number of sheets you intend to print
• Correct the curl amount before setting the paper
• Turn over the paper so that the paper is with a concave curl.
6. Paper Specifications and Adding Paper
180
To Next Page
Loading...
