• When paper in trays that are set to automatically eject unnecessary tab stock sheets runs out,
reload the tab stock from the beginning of the cycle (the first sheet).
• When you load paper into the paper tray for the first time or when you change the size or type of
paper in the paper tray, be sure to specify the appropriate paper settings in Tray Paper Settings.
For details, see page 241 "Changing Tray Paper Settings".
• For details about the paper sizes and types that can be used, see page 207 "Recommended
Paper Sizes and Types".
• You might at times hear a rustling noise from paper moving through the machine. This noise does
not indicate a malfunction.
Fanning the paper
• If you load coated paper, label paper, or thick paper of 163.1–360.0 g/m
2
(60.1 lb. Cover–
198.0 lb. Index) in the three-tray wide LCT, it is important that you fan the sheets thoroughly.
Misfeeds may occur if paper is not fanned thoroughly.
1. Loosen the stack by riffling the sheets.
2. Holding its shorter ends, flex the stack back and forth to create space between the sheets.
Repeat this several times.
Loading Paper
171
To Next Page
Loading...
