Ricoh PRO C7200S - Finishing: Finisher

Setting Items Description
PCU Cleaning Unit (K)
Charger Unit (K)
Photoconductor Unit (K)
PCU Cleaning Unit (C)
Charger Unit (C)
Photoconductor Unit (C)
PCU Cleaning Unit (M)
Charger Unit (M)
Photoconductor Unit (M)
PCU Cleaning Unit (Y)
Charger Unit (Y)
Photoconductor Unit (Y)
PCU Cleaning Unit (S)
Charger Unit (S)
Photoconductor Unit (S)
ITB Cleaning Unit
Paper Transfer Unit
Fuser Unit
Fusing Belt Smoothing Rlr
Fuser Cleaning Unit
Ozone Filter (Main)
Dust Filter (Main)
Tray 1
Tray 2
3-Tray LCIT: Tray 3
3-Tray LCIT: Tray 4
3-Tray LCIT: Tray 5
Bypass Tray
Interposer Upper Tray
Interposer Lower Tray
ADF
2-Tray LCIT:Tray3:Fd Blt
2-Tray LCIT:Tray4:Fd Blt
2-Tray LCIT:Tray5:Fd Blt
2-Tray LCIT:Tray6:Fd Blt
2-Tray LCIT:Tray7:Fd Blt
2-Tray LCIT:Tray8:Fd Blt
The counter value of
the replacement part is
displayed.
When it reaches the
time to replace, a
message will be shown
to prompt the
replacement.
Finishing: Finisher
0601 Staple Position: Across Feed 1
Adjust the vertical position of the staple (applied at an edge) when using Finisher SR5050 or Booklet
Finisher SR5060.
Press [ ] to move the stapling position away from the side edge of the sheet or [ ] to move it toward the
edge.
Setting Values
303