• The machine is configured to continue printing manually.
• [Auto Continue] is specified.
• Tray A is specified as the source tray.
• [Driver / Command] is selected in [Tray Setting Priority] for the specified source tray.
• Slip Sheets is specified.
• Separation Sheets is specified.
• The staple function is specified.
• The punch function is specified.
• The fold function is specified.
• Paper is ejected with its printed side facing up.
• Perfect Binding is specified.
• Ring binder is not attached.
• Ring combs have run out.
• The hole punch receptacle is full.
• Ring Binding cannot be used for the selected tray, paper size, or paper type.
• Ring Binding cannot be used for the selected paper orientation.
• The number of printed sheets exceeds 50 when Ring Binding with 50-sheet type ring combs is
specified.
• The number of printed sheets exceeds 100 when Ring Binding with 100-sheet type ring
combs is specified.
• Sheets of paper to be bound with 50-sheet type ring combs are thicker than 50 sheets of plain
paper.
• Sheets of paper to be bound with 100-sheet type ring combs are thicker than 100 sheets of
plain paper.
• Ring combs are set in reverse orientation.
• Ring combs of a size that is not supported by the ring binder are used.
• The punch unit is not attached.
• Different types of ring combs (50-sheet type and 100-sheet type ring combs) are used
together.
Functions that will be canceled when the Ring Binding is applied to bind sheets of paper
The following functions will be canceled when specified with Ring Binding at the same time:
• Stack
• Extended Auto Tray Switching
Ring Binding
31
To Next Page
Loading...
