Rigol DS1104Z Programming Guide

Chapter 2 Command System RIGOL
DS1000Z Programming Guide 2-1
Chapter 2 Command System
This chapter introduces the syntax, function, parameter and using instruction of each DS1000Z command.
Main topics of this chapter:
 :AUToscale
 :CLEar
 :RUN
 :STOP
 :SINGle
 :TFORce
 :ACQuire Commands
 :CALibrate Commands
 :CHANnel<n> Commands
 :CURSor Commands
 :DISPlay Commands
 IEEE488.2 Common Commands
 :MATH Commands
 :MASK Commands
 :MEASure Commands
 :REFerence Commands
 [:SOURce[<n>]] Commands (DS1000Z-S Only)
 :SYSTem Commands
 :TIMebase Commands
 :TRIGger Commands
 :WAVeform Commands
Note:
1. Unless otherwise noted, this manual takes DS1104Z-S as an example to introduce the commands.
2. For parameter setting commands (for example, the time, frequency and amplitude), the oscilloscope
can only accept numbers and set the parameters using the default units; it cannot recognize the units
sent with the parameters. For the default unit of each parameter, please refer to the description in each
command in the following introductions.

Rigol DS1104Z Specifications

General

Brand	Rigol
Model	DS1104Z
Category	Test Equipment
Language	English