Rigol DS1104Z Programming Guide

RIGOL Chapter 3 Programming Demos
3-2 DS1000Z Programming Guide
Programming Preparations
Before programming, you need to make the following preparations:
Make sure that your PC has installed the NI-VISA library (can be downloaded from NI website:
http://www.ni.com/visa/). Here, the default installation path is C:\Program Files\IVI Foundation\VISA.
Here, the USB interface of the oscilloscope is used to communicate with the PC and please use a USB cable
to connect the USB Device interface at the rear panel of the oscilloscope to the PC. After successful
connection, turn on the instrument. A "Found New Hardware Wizard" dialog box appears on the PC at
the first connection. Please follow the instructions to install the "USB Test and Measurement Device".
By now, the programming preparations are finished. In the following part, detailed introductions are given
about the programming demos in the Excel, Labview, Matlab, Visual Basic 6.0 and Visual C++ 6.0
development environments.

Rigol DS1104Z Specifications

General

Bandwidth	100 MHz
Channels	4
Sample Rate	1 GSa/s
Waveform Capture Rate	30, 000 wfms/s
Vertical Sensitivity	1 mV/div to 10 V/div
Time Base Range	5 ns/div to 50 s/div
Vertical Resolution	8 bits
Interface	USB Host, USB Device, LAN, AUX
Display	7 inch TFT LCD (800 x 480)
Trigger Types	Edge, Pulse, Video, Slope
Power Supply	100-240 V, 45-440 Hz
Memory Depth	24 Mpts (Single Channel), 12 Mpts (Dual Channel)