➢ To delete a Proximity tag by its tag:
1. Enter your Grand Master code, and then press OK.
2. Scroll to the Codes/Tags menu, and then press OK.
3. Scroll to Delete By Tag, and then press OK.
4. Within 10 seconds, hold the tag about 2 cm (1 inch) directly above the keypad's built-in
Proximity sensor; TAG DELETED displays and the keypad sounds a beep, indicating the
successful deletion.
NOTE: If a tag is not registered, if you position it over the keypad's Proximity sensor
TAG NOT DEFINED IN MEMORY displays.
Deleting My Own Proximity Tag
➢ To delete your own (non-Grand Master) Proximity tag:
1. Enter your user code, and then press OK.
2. Scroll to Codes/Tags, and then press OK.
3. Scroll to Delete My Tag, and then press OK.
4. At the "ARE YOU SURE?" prompt, use the Partial Arm button (see table in Keypad
Buttons, page 12) to toggle to Y (yes) to delete it, or to N (no) to cancel the operation.
5. Press OK; if deleted, the keypad beeps and DELETED displays.
To Next Page
Loading...
