a. At the One-Time-Only option, press OK.
b. Scroll through the zones to one for which you want to
change its bypass status.
c. Toggle to either Y (to bypass) or N (to un-bypass), and
then press OK.
a. At the Permanent Bypass option, press OK.
b. Scroll through the zones to one for which you want to
permanently bypass.
c. Toggle to either Y (to bypass) or N (to un-bypass), and
then press OK.
a. At the Bypass Reset option, press OK.
b. Press OK again to confirm; the keypad beeps, indicating
that all zones have been reset to a
not-bypassed (default) state.
a. At the Bypass Recall option, press OK, then press OK
again to confirm.
b. Scroll through the zones to view that previously
un-bypassed zones are again bypassed. You can also
toggle to N at any zone to cancel its bypass state.
c. Press OK; the keypad beeps, indicating the successful
operation.
Quickly Bypassing/Un-Bypassing Zones on a One-Time Basis
If installer-configured, you can quickly access the "one-time-only" bypass option (see table
above). This may be useful, for example, if you want to bypass zone(s) on a one-time basis,
or if you have previously permanently bypassed zone(s) and you want to un-bypass them
on a one-time basis.
➢ To perform a quick "one-time-only" bypassing/un-bypassing of zones:
1. At the keypad, enter your Grand Master or user code (don't enter OK after).
2. Press a scroll key; you will be prompted to bypass the first zone (zone 1).
3. Scroll to the zone you want to bypass, and then toggle using the Partial Arm button to
either Y to bypass or N to un-bypass.
4. Scroll to additional zone(s) as needed and repeat step 3 for each.
5. When finished, press OK.
To Next Page
Loading...
