You can define up to 64 re-occurring weekly schedules for automatic UO
activation/deactivation and automatic system arming/disarming. Each schedule can have
up to 2 separate start and stop time intervals per day. For an automatic arming/disarming,
you can also set a "user limitation" safeguard to prevent the users you specify from
disarming the system during the times you specify.
➢ To define a weekly schedule:
1. At the keypad, enter your Grand Master code, and then press OK.
2. Scroll to Clock and then press OK.
3. Scroll to Scheduler and then press OK.
4. Scroll to Weekly and then press OK.
5. Scroll to select the schedule number you are defining (1—64), then press OK.
6. Scroll to select from the following options for the selected schedule, then press OK, and
then proceed to perform the respective configuration procedures in the tables below.
• 1)ARM/DISARM
• 2)UO ("UO ON/OFF")
• 3)USER LIMIT
NOTE: When finished configuring an option, you can select and configure from the
other options above.
Turning an Arming/Disarming Schedule On or Off
1. Scroll to 1)ON/OFF, and then press OK.
2. Toggle to ON or OFF to turn the automatic arming schedule on or off respectively, and
then press OK.
Defining Partitions for the Arming/Disarming Schedule
1. Scroll to 2)PARTITION, and then press OK.
2. Select partitions to arm/disarm. As the partitions are grouped in blocks of 10, scroll to
the relevant block and then select the partitions by entering
the respective partition numbers.
3. Press OK.
To Next Page
Loading...
