[For the 3-amp Power Supply Module only]: In the event of an overload of the system's
power supply, you can attempt to restore the system by yourself.
IMPORTANT: If the following procedure does not resolve the situation, it will require the
intervention of a technician/installer.
WARNING: Do not ever attempt to open the system's main panel or perform any
service/repair yourself, as doing so can result in death, injury or damage – always contact a
professional alarm system technician/installer.
➢ To restore the system after a power supply overload:
1. At the keypad, enter your Grand Master code, and then press OK.
2. At Activities press OK.
3. Scroll to Advanced and then press OK.
4. Scroll to Overload Restore and then press OK.
To Next Page
Loading...
