Risco LightSYS Plus - Appendix C: System Indicators; Sound Indicators; Beep and Squawk Sound Indicators

01/2022
Page 85
5IN2933
Appendix C: System Indicators
Various audible (sound) indicators and visual (viewed) indicators are available, depending
on the system configuration.
Sound Indicators
Sound indications are available for system status, operations and events:
• Beeps and squawks
• Voice announcements
Sound indicators are requested / initiated from keypads and remote controls, and the
sounds can be heard from the keypads, remote controls and external sirens.
"Beep" and "Squawk" Sound Indicators
The following table below shows the "beep" and "squawk" sound indications that are heard
when requested / initiated from keypads, remote controls and keyfobs:
Requested / initiated from: 8-button remote control
Operation / event
Sounds from remote control
Sounds from siren
Confirmation
1 beep
No sound
Error
3 beeps
No sound
Alarm
5 beeps
No sound
Arming / disarming
1 beep
Armed = 1 squawk
Disarmed = 2 squawks (or 4 if
disarmed after an alarm)
Requested / initiated from: 4-button keyfob
Operation
Sounds from keyfob
Sounds from siren
Arming / disarming
No sound
Armed = 1 squawk
Disarmed = 2 squawks (or 4 if
disarmed after an alarm)
Requested / initiated from: Slim keypad
Operation / event
Sounds from keypad
Sounds from siren
Confirmation
1 long beep
No sound
Wrong code
3 short beeps
No sound
Entry/exit beeps
Slow repeating beeps until end
of delay period
(2)
Fast beeps at
end of delay period.
No sound