5. Leave the premises before the end of the exit delay period. During the exit delay period,
you can observe the following indicators at the keypad:
• The keypad beeps slowly and repeatedly, followed by faster beeps at end of
exit delay time period
• The exit-delay countdown appears on the keypad display, and the full arm
icon flashes. On the LightSYS keypad the red LED is flashing.
NOTE: You can press the current keypad's Exit button during the exit delay time
period to silence the beeps (other keypads in the system will still beep).
6. At the end of the exit delay time period, the Full-Arm icon appears without blinking,
and ARMED displays. On the LightSYS keypad, the red LED is lit without flashing.
Partial ("Stay" or "Home") Arming
Partial arming allows the non-armed areas of the premises to be inhabited.
➢ To partially arm the system:
1. Verify that the system is ready to be armed (view the READY indicator).
2. If not ready to arm, secure (or bypass) any open zones see Bypassing Zones (Arming with
Manually-Bypassed Zones), page 56 and also Forced Arming (Arming with Automatically-
Bypassed Zones), page 55.
3. If unable to arm, scroll to view system trouble messages, and resolve accordingly. If
installer-defined, you can arm while overriding all current troubles (see Arming with
System Troubles, page 55).
4. Perform the following arming procedure in the table below.
NOTES:
• If you enter your code incorrectly, three short beeps will sound. Re-enter the code.
• Keyfob and remote control buttons can have different functions and are
installer-defined.
• Proximity arming is installer-defined, and can vary per system user.
To Next Page
Loading...
