Risco LightSYS Plus - Disarming an Individual Partition

01/2022
Page 58
5IN2933
Disarming an Individual Partition
You can disarm 1 individual partition at a time (as fully-armed or partly-armed).
➢ To disarm an individual partition:
1. If outside the premises, open a designated "entry" door. The keypad beeps, indicating
that the entry delay time period has started.
2. Before the end of the entry delay time period, perform the following procedure:
NOTES:
• If you enter your code incorrectly, three short beeps will sound.
Re-enter the code.
• Upon disarming, a confirmation beep or squawk may sound.
For this:
Do this to disarm an INDIVIDUAL partition:
❖ Disarm an individual partition: Enter code ➢ press disarm button ➢
enter the 2-digit partition number (example 03) ➢ press disarm button.
❖ Proximity disarm: Place tag ➢ enter the 2-digit partition number
(example 03) ➢ press disarm button
NOTE: You can select only partition 1, 2, or 3 to disarm only that specific
partition. Other partitions cannot be separately disarmed from the
keypad.