4. At Activities press OK.
5. Scroll to Config SW, and then press OK; either CS CONNECT or ENABLE CS displays:
• [If ENABLE CS displays]: The system is not currently configured to allow the
technician/installer to access the CS. For you to authorize the technician/installer a
one-time access to the CS, press OK, scroll to CS Connect, and then proceed to step
6.
• [If CS CONNECT displays]: The system is currently configured to allow the
technician/installer to access to the CS. Proceed to step 6.
6. At CS Connect press OK.
7. Scroll to the communication channel that the technician/installer computer will utilize to
communicate with the system (IP or GSM).
8. Press OK; DONE displays, and the technician/installer now has a 1-hour time limit to
perform a CS reset of the system.
Disabling Smoke/Heat Detectors after Alarm Activation
After a fire alarm, the Grand Master can disable the activated smoke/heat detector(s) in the
system for an installer-set interval of up to 90 seconds in order to reset the detectors for
normal operation.
➢ To disable a fire alarm:
1. At the keypad, enter your Grand Master code, and then press OK.
2. At Activities press OK.
3. Scroll to Advanced and then press OK.
4. At Switch Aux press OK; the keypad beeps and the smoke/heat alarms are disabled.
5. You may need to repeat this procedure until the detectors no longer detect any
remaining smoke or heat.
To Next Page
Loading...
