If installer-configured, you can perform either the following procedure to bypass zones, or
the quick procedure for one-time-only bypassing (see Quickly Bypassing/Un-Bypassing Zones
on a One-Time Basis, page 44).
➢ To define a zone's bypass status:
1. At the keypad, enter your Grand Master or user code, and then press OK.
2. Scroll to Activities and then press OK.
3. At Bypass press OK.
4. At Zones press OK.
5. Scroll to select from the following bypass options:
• One Time Only: Bypasses the selected zone once only – at the next system arming
(the zones will then not be bypassed at subsequent armings)
• Permanent Bypass: Bypasses the selected zone on a continual basis, upon each
system arming
• Bypass Reset: Un-bypasses (removes the bypass) for all zones
• Bypass Recall: Reverts to the most recent zone-bypass state (if a Bypass Reset was
recently performed)
6. Perform the following additional steps in the table below, according to the option you
select:
NOTES:
• The default for all zones is N (not bypassed)
• If a zone is bypassed, the full arming indicator does not display on the keypad
when in full arming (Away arming) mode
To Next Page
Loading...
