You can terminate the transmission of FM notifications to the recipients – for example, for a
false alarm, where you don’t want the recipients to get notified.
➢ To terminate Follow Me notifications:
1. At the keypad, enter your Grand Master code, and then press OK.
2. Scroll to Follow Me and then press OK.
3. Scroll to Terminate FM and then press OK; notification transmissions to all remaining
FM destinations are stopped.
Cancelling Monitoring Station Notification upon Installer
Programming
If the system is configured to require the Grand Master to notify the monitoring station when
a installer/technician configures programs the system (for any time after initial system setup
and programming), the Grand Master can select Void Report Programming to cancel
sending the notification report to the monitoring station, and still allow the installer to
program the system. The installer will then have 5 minutes to gain access to the installer
Programming menu.
➢ To allow installer programming without monitoring station notification:
1. At the keypad, enter your Grand Master code, and then press OK.
2. At Activities press OK.
3. Scroll to Advanced, and then press OK.
4. Scroll to Void Report Programming, and then press OK; the installer has 5 minutes to
gain access to the Programming menu.
Testing the System
The following tests are recommended to be performed at system installation, and
subsequently, as needed. Ask your installer if they have already been performed during the
system installation.
To Next Page
Loading...
