Changing the Keyfob Buttons for Output Control
[For the 4-button keyfob]: By default the small and large circular/oval buttons are used for
controlling the outputs. After registering, either the Grand Master or installer can change the
functionality of the keyfob buttons so that the buttons with printed "locked" and "unlocked"
symbols will be used for output control instead.
[For the 8-button remote control]: Only the installer defines the buttons used for output
control.
➢ To change the keyfob buttons used for output control:
1. At the keypad, enter your Grand Master code, and then press OK.
2. Scroll to Stand Alone KF (keyfob), and then and press OK.
3. Scroll to select the wireless expander ("receiver") that you want to assign the keyfob to
and press OK.
4. Scroll to UO Buttons, and then press OK; ARE YOU SURE? displays.
5. Toggle to Y (yes), or to cancel the operation toggle to N (no), and then press OK; the
keypad sounds a confirmation beep.
Deleting the Registration for a Single Output Control Keyfob
The Grand Master must delete the registrations for all output control keyfobs/remote
controls that are no longer used, to prevent unauthorized usage.
➢ To delete a keyfob/remote control registration:
1. At the keypad, enter your Grand Master code, and then press OK.
2. Scroll to Stand Alone KF (keyfob), and then and press OK.
3. Scroll to select the specific wireless expander ("receiver") that the keyfob is assigned to,
and then press OK.
4. Scroll to Delete Keyfob, and then press OK.
5. Press OK to start Erase mode (registration deletion mode).
6. At the keyfob, do the following:
• [4-button keyfobs]: Press for about 3 seconds until the keypad beeps.
• [8-button remote controls]: Press and simultaneously for about
3 seconds until the keypad beeps.
7. Back at the keypad, press OK to stop Erase mode.
To Next Page
Loading...
