Roche Cedex Bio - Page 468

Roche Diagnostics
F-18
Operator’s Manual · Version 3.4
14 ISE operation Cedex Bio analyzer
Daily operation
7
Performing calibrations
Performing individual
calibrations
1. Start the wizard. Wo rk p lac e > Calibrations >
2. Select the test. n/a
3. Prepare and place the calibrators. n/a
4. Start the calibration.
5. Validate the calibration results. Workplace > Calibrations >
6. Remove the calibrators.
Performing
all due calibrations
1. Start the wizard. Wo rk p lac e > Calibrations >
2. Select all tests with due calibrations.
or
Select all tests with calibration due
within the forecast period.
n/a
3. Prepare and place the calibrators. n/a
4. Start the calibration.
5. Validate the calibration results. Workplace > Calibrations >
6. Remove the calibrators.
8
Performing controls
Performing
Default QC
1. Start the wizard. Overview > Order >
2. Select a control and place the tube.
Repeat until there are no controls left
on the screen.
n/a
3. Start the QC measurement.
4. Validate the QC results. Workplace > QC Status >
5. Remove the controls. n/a
Task Steps Navigation
With wizard As individual steps
Table F-3
Overview of the daily operation tasks (Continued)