Roche Cedex Bio - Page 469

Roche Diagnostics
Operator’s Manual · Version 3.4 F-19
Cedex Bio analyzer 14 ISE operation
Daily operation
Performing an individual
QC measurement
1. Start the wizard. Wo rk p lac e > QC Status >
2. Select a test. n/a
3. Select a control and place the tube.
Repeat until there are no controls left
on the screen.
n/a
4. Start the QC measurement.
5. Validate the QC results. Workplace > QC Status >
6. Remove the control.
Performing all
due QC measurements
1. Start the wizard. Overview > Order >
>
2. Select a control and place the tube.
Repeat until there are no controls left
on the screen.
n/a
3. Start the QC measurement.
4. Validate the QC results. Workplace > QC Status >
5. Remove the controls.
Task Steps Navigation
With wizard As individual steps
Table F-3
Overview of the daily operation tasks (Continued)