Rohde & Schwarz CMW500 - Page 238

Command Reference - Base Software
R&S
®
CMW500
222User Manual 1173.9463.02 ─ 06
Parameters:
'<StorageUnit>' String parameter to specify the default storage unit
*RST: a *RST does not change the default storage unit
Example:
MMEM:MSIS 'E:'
Sets the default storage unit to drive E
Example:
MMEM:MSIS '\\Server\Share'
Sets the default storage unit to the specified server
Usage: SCPI confirmed
Firmware/Software: V1.0.0.4
MMEMory:
RCL '<FileSource>'
Restores the instrument settings from the specified file.
This command has the same effect as the combination of MMEMory:LOAD:STATe and
*RCL.
Parameters:
'<FileSource>' String parameter specifying the path and filename of the source
file. Wildcards are not allowed.
Example:
MMEM:RCL '@SAVE\mysavefile.dfl'
Loads and activates the instrument settings from the file
mysavefile.dfl located in the directory assigned to the
@SAVE alias.
Usage: Event
Firmware/Software: V2.0.10
MMEMory:RDIRectory '<DirectoryName>'
Removes an existing empty directory from the mass memory storage system.
Parameters:
'<DirectoryName>' String parameter to specify the directory. Wildcards are not
allowed.
Example:
MMEM:RDIR 'D:\Rohde-Schwarz\CMW\Data\User1'
Removes the directory User1
Usage: Event
Firmware/Software: V1.0.0.4
MMEMory:SAV '<FileDestination>'
Stores the current instrument settings to the specified file.
This command has the same effect as the combination of *SAV and
MMEMory:STORe:STATe.
Instrument-Control Commands