Rohde & Schwarz CMW500 - Page 276

Command Reference - Base Software
R&S
®
CMW500
260User Manual 1173.9463.02 ─ 06
STATus:OPERation:TASK:A:<netw_std>:<func_grp>:ENABle <MaskBits>
STATus:OPERation:TASK:A:<netw_std>:<func_grp>:<appl>:ENABle <MaskBits>
Sets the enable mask which allows true conditions in the EVENt part of the status register
to be reported in the summary bit. If a bit is 1 in the enable register and its associated
event bit transitions to true, a positive transition will occur in the summary bit reported to
the next higher level. See also Structure of an SCPI Status Register.
For a description of the variables <netw_std>, <func_grp> and <appl> refer to table 6-1.
Parameters:
<MaskBits> Range: 0 to 65535 (decimal representation)
Example:
STAT:OPER:TASK:A:GPRF:MEAS:ENAB 1536
Set bits no. 9 and 10 of the ENABle part of the status register for
GPRF measurements (1536 = 512 + 1024 = 2
9
+ 2
10
).
Firmware/Software: V1.0.4.11
STATus:OPERation:ESRQ <MaskBits>
STATus:OPERation:TASK:ESRQ <MaskBits>
STATus:OPERation:TASK:A:ESRQ <MaskBits>
STATus:OPERation:TASK:A:<netw_std>:ESRQ <MaskBits>
STATus:OPERation:TASK:A:<netw_std>:<func_grp>:ESRQ <MaskBits>
STATus:OPERation:TASK:A:<netw_std>:<func_grp>:<appl>:ESRQ <MaskBits>
Sets the enable mask for the register to the specified value. Also sets the relevant bit in
the enable mask of all higher registers up to the STATus:OPERation register and the
SRE. Thus the entire reporting path from the register up to the SRE is enabled so that
an SRQ can be generated.
If the enable mask is set to 0, the higher registers are not modified.
For a description of the variables <netw_std>, <func_grp> and <appl> refer to table 6-1.
Parameters:
<MaskBits> Range: 0 to 65535 (decimal representation)
Example:
STAT:OPER:TASK:A:GPRF:MEAS:POW:ESRQ 4
Sets bit no. 2 (decimal 4) and disables all other bits in the ENABle
part of the following status register:
STAT:OPER:TASK:A:GPRF:MEAS:POW
Also sets the relevant bit in the ENABle part of the following status
registers, without changing the other bits of these ENABle parts:
STAT:OPER:TASK:A:GPRF:MEAS: set bit no. 0
STAT:OPER:TASK:A:GPRF: set bit no. 0
STAT:OPER:TASK:A: set bit no. 1
STAT:OPER:TASK: set bit no. 0
STAT:OPER: set bit no. 9
SRE: set bit no. 7
Firmware/Software:
V2.0.10
Instrument-Control Commands