Rohde & Schwarz CMW500 - Page 299

Command Reference - Base Software
R&S
®
CMW500
283User Manual 1173.9463.02 ─ 06
Example:
SYSTem:SIGNaling:ALL:OFF
Switches off all signaling applications. Same effect like pressing
ON | OFF for all signaling applications currently generating a sig-
nal.
Usage: Event
Firmware/Software: V2.1.26
SYSTem:DISPlay:UPDate <Enable>
Defines whether the display shall be updated or not while the instrument is in the remote
state. If the display (update) is switched off, the normal GUI is replaced by a static image
while the instrument is in the remote state. Switching off the display can speed up the
measurement. This is the recommended state.
See also chapter 5.1.3.1, "Using the Display during Remote Control", on page 121
Parameters:
<Enable> ON | 1: Display is shown and updated during remote control
OFF | 0: Display shows static image during remote control
Example:
SYSTem:DISPlay:UPDate ON
Switch on the display update.
Firmware/Software: V1.0.5.3
SYSTem:KLOCk <State>
Locks or unlocks the local controls of the instrument. This includes the front panel keys,
the keyboard, or other local interfaces.
Parameters:
<State> ON | OFF
ON: Local key locked (key lock enabled)
OFF: Local keys unlocked
*RST: OFF
Example:
SYSTem:KLOCk ON
Lock the local keys.
Usage: SCPI confirmed
Firmware/Software: V1.0.0.4
SYSTem:VERSion?
Queries the SCPI version number to which the instrument complies. The instrument
complies to the final SCPI version 1999.0.
Usage:
Query only
SCPI confirmed
Firmware/Software: V1.0.0.4
Instrument-Control Commands