Getting Started
R&S
®
CMW500
24User Manual 1173.9463.02 ─ 06
Connectors available on all instruments
●
LAN REMOTE is an RJ-45 connector. Use this connector to integrate the instrument
to a Local Area Network, primarily for remote control purposes.
●
REF IN is a BNC input for an external reference frequency. Use this connector to
synchronize the R&S CMW500 to another device.
● REF OUT 1 is a BNC output for the internal reference frequency of the R&S CMW500.
Use this connector to synchronize other instruments to the tester.
●
The USB connectors can be used to connect e.g. a keyboard, mouse or other pointing
devices, a printer or an external storage device (USB stick, CD-ROM drive etc.). To
prevent instrument damage, observe the hints given in "USB Connectors"
on page 22.
●
The USB REMOTE connector can be used for remote control of the instrument.
●
TRIG A and TRIG B are two BNC connectors for external trigger signals.
Optional connectors
●
A LAN SWITCH with two RJ-45 connectors is available as option R&S CMW-B660A
and R&S CMW-B661A. The connectors provide access to the internal IP network
(CMW subnet), e.g. for message logging.
●
The BNC connectors SYS SYNC OUT 1, OUT 2, OUT 3 and SYS SYNC IN are
provided with option R&S CMW-S550M. They are used to provide or receive time
information.
●
LAN DAU is an RJ-45 connector. It is provided with the Data Application Unit (DAU),
option R&S CMW-B450A. You can connect an external network to this connector for
data transfer tests / U-plane tests.
●
An I/Q board is available as option R&S CMW-B510A / -B510F. It provides four digital
connectors (labeled "DIG IQ IN 1", "DIG IQ OUT 2", "DIG IQ IN 3", and "DIG IQ OUT
4") for input and output of digital IQ data plus two bidirectional BNC connectors
(labeled "AUX A" and "AUX B") for control, clock and trigger signals.
Instrument Tour
To Next Page
Loading...
