Rohde & Schwarz PR100 - Page 118

R&S PR100 User Manual
d
DISPlay
. :IFPan
. . :LEVel
. . . :REFerence? [MINimum|MAXimum]
Query of maximum signal-level that can be displayed in an IFPan view
Parameter:
none query of current reference level
MINimum|MAXimum query of lowest|highest reference level
Result:
reference level in dBZV
Example:
DISPlay:IFPan:LEVel:REFerence? -> 40
d
DISPlay
. :LEVel
. . :LIMit
. . . :MINimum <numeric_value>|MINimum|MAXimum
Sets the lower limit for the level-bar display. Signal-level with lower values
cannot be distinguished (i.e. are displayed with the same size of level bar).
This setting only applies if the tone mode if off (OUTP:TONE:STAT OFF). If
tone mode is on, the device determines the lower limit itself.
Parameters:
<numeric_value> signal-level in dBZV
MINimum|MAXimum lowest|highest signal-level
Example:
DISPlay:LEVel:LIMit:MINimum 20