Turning the Power On
31
Introduction Playing Sounds Editing Sounds
Other Convenient
Functions
Connecting Other
Equipment
Appendix
Quick Guide
Once everything is properly connected (p. 28), be sure to follow the procedure below to turn on their power. If you turn on equipment in the wrong
order, you risk causing malfunction or equipment failure.
Turning the Power On
* Before turning the unit on/o, always be sure to turn the volume down. Even with the volume turned down, you might hear some sound when
switching the unit on/o. However, this is normal and does not indicate a malfunction.
1. Minimize the volume of the JUPITER-50 and your speakers.
2. On the JUPITER-50’s rear panel, turn the [POWER] switch ON.
* This unit is equipped with a protection circuit. A brief interval (a few seconds) after turning the unit on is required before it will operate normally.
3. Turn on the power of your speakers.
4. Use the [VOLUME] knob to adjust the volume appropriately.
NOTE
With the factory settings, the JUPITER-50 will automatically be switched o four hours after you stop playing or operating the unit.
If you don’t want the unit to turn o automatically, change the “Auto O” setting to “OFF” as described on p. 79.
• The settings you were editing will be lost when the unit is turned o. If you want to keep your settings, you must save your
settings before turning the unit o (p. 34).
• When turning the power back on after it was turned o by the Auto-O function, you must wait at least 10 seconds before turning the power
on. If you do not allow this interval to pass, the Auto-O function might not be reset, and the power might not turn on normally.
Turning the Power O
1. Minimize the volume of the JUPITER-50 and your speakers.
2. Turn o the power of your speakers.
3. Turn the JUPITER-50’s [POWER] switch OFF.
Turning the Power On
To Next Page
Loading...
