Roland Jupiter-50 - Adjusting the Effect Send Levels and Effect Output Levels; Editing the MFX; Editing the Reverb

Editing a Live Set
59
Introduction Playing Sounds Editing Sounds
Other Convenient
Functions
Connecting Other
Equipment
Appendix
Quick Guide
Adjusting the Eect Send Levels and
Eect Output Levels
You can adjust the level at which the sound of each layer is sent to
MFX, and the output level of the sound that has passed through the
eect.
Set the level of sound sent to
MFX or reverb.
Set the level of sound sent from
MFX to reverb.
Set the output destination and
output level of the selected layer.
Set the output level of MFX or
reverb.
Editing the MFX
To edit MFX settings, access the MFX parameter screen.
1. In the LIVE SET (UPPER) screen (p. 36), press the [F3]
(EFFECT) button.
2. Press the button to which the eect you want to edit is
assigned, from [F1] (MFX 1) through [F4] (MFX 4).
The MFX parameter screen will appear.
Use the [F1] (MFX 1)–[F4] (MFX 4) buttons to switch between
screens.
3. Edit the MFX settings.
From the MFX edit screen, pressing [F5] (CTRL) button will take you
to the MFX control edit screen.
For details on MFX parameters, refer to the parameter list in the PDF
manual.
Editing the Reverb
To edit Reverb settings, access the Reverb parameter screen.
1. In the LIVE SET (UPPER) screen (p. 36), press the [F3]
(EFFECT) button.
2. Press the [F5] (Reverb) button.
The Reverb parameter screen will appear.
3. Edit the Reverb settings.
The parameters that can be edited will depend on the eect type
you’ve selected. For details on Reverb parameters, refer to the
parameter list in the PDF manual.