Roland Jupiter-50 - Playing the JUPITER-50 from an External MIDI Device; Setting the Receive Channel; Setting the Program Change Receive Switch

Connecting an External MIDI Device
83
Introduction Playing Sounds Editing Sounds
Other Convenient
Functions
Connecting Other
Equipment
Appendix
Quick Guide
Playing the JUPITER-50 from an
External MIDI Device
Connection example
MIDI OUT connector
MIDI IN connector
MIDI keyboard
JUPITER-50
Setting the Receive Channel
You’ll need to match your external MIDI device’s transmit channel
with the JUPITER-50’s receive channel.
1. In the SYSTEM SETUP screen (p. 75), press the [F4] (MIDI)
button .
2. Use the Part Channel settings (UPPER, SOLO, PERC/
LOWER) to specify the MIDI channel for each part.
3. To save the settings, press the [WRITE] button.
The screen will ask “Are you sure?”
4. Press the [F5] (OK) button.
A message will indicate “Completed!” and the settings will be saved.
Setting the Program Change Receive
Switch
Here’s how to on/o the receive switch for program change and
bank select messages. With the factory settings, both are turned
“ON.”
1. In the SYSTEM SETUP screen (p. 75), press the [F4] (MIDI)
button.
2. Turn ON the “Receive Program Change” and “Receive Bank
Select” settings under “MIDI Receive.”
3. To save the settings, press the [WRITE] button.
The screen will ask “Are you sure?”
4. Press the [F5] (OK) button.
A message will indicate “Completed!” and the settings will be saved.
MEMO
• For details on these settings, refer to “MIDI ([F4] button)” (p. 77).
• For details on how to set the transmit channel of your external
MIDI device, refer to its owner’s manual.