Roland Jupiter-50 - Using the Part Sound Buttons to Switch the Solo Part’s Tone; Switching the Tone of the Percussion;Lower Part

Selecting the Sound for Each Part (Selecting Live Sets / Tones)
41
Introduction Playing Sounds Editing Sounds
Other Convenient
Functions
Connecting Other
Equipment
Appendix
Quick Guide
Using the Part Sound Buttons to
Switch the Solo Part’s Tone
You can use the Part sound buttons to switch the tone of the Solo
Part.
1. Access the Top screen (p. 35), and press one of the part
sound buttons (SOLO tone buttons) of the Solo Part.
SOLO
The sound of the Solo Part will be switched.
2. By pressing the same part sound button once again, you
can select sounds from a list.
3. Press the [F1] (SN.AC) or [F2] (SN.SYN) button.
Button Explanation
[F1] (SN.AC) SuperNATURAL acoustic tone
[F2] (SN.SYN) SuperNATURAL synth tone
4. Use the [ ] [ ] (cursor) buttons to select a category.
5. Use the [ ] [ ] (cursor) buttons to select a tone.
6. Press the [ENTER] button.
Sound buttons and sound categories
The sound buttons correspond to the following sound categories.
Button Category Explanation
VIOLIN Solo Strings Solo strings such as violin
TRUMPET/SAX
Solo Brass Brass instruments such as trumpet
Sax Sax
FLUTE/OBOE
Flute Flute
Wind Woodwinds such as oboe
OTHER All Categories
All sounds
* The SuperNATURAL Acoustic
Tone 0028: TW Organ cannot be
selected.
MEMO
• The sound that is selected when you press a sound button is
determined by the “LIVE SET/TONE BUTTONS” (p. 78).
• If you move the cursor to the sound number of the Solo Part and
press the [ENTER] button, a list of Tones for all categories will
appear.
Switching the Tone of the
Percussion/Lower Part
The sound of the Percussion/Lower Part can be switched from the
Tone List.
1. Press the [LOWER TONE] or [PERC] button so it’s lit.
2. In the Top screen, move the cursor to the sound number
of the Percussion/Lower Part, and press the [ENTER]
button.
The Tone List will appear.
3. Press the [F1] or [F2] button.
If LOWER TONE is selected
Button Explanation
[F1] (SN.AC) SuperNATURAL acoustic tone
[F2] (SN.SYN) SuperNATURAL synth tone
If PERC is selected
Button Explanation
[F1] (DRUMS) Drums
[F2] (M.PERC) Manual Percussion
4. Use the [ ] [ ] (cursor) buttons to select a category.
5. Use the [ ] [ ] (cursor) buttons to select a tone.
6. Press the [ENTER] button.
MEMO
For details on selecting percussion sounds, refer to “Playing
Drum Sounds and Sound Eects (Percussion/Lower)” (p. 43).