Roland Jupiter-50 - Placing the JUPITER-50 on a Stand

30
Be careful not to pinch your ngers when setting up the stand.
If you want to place the JUPITER-50 on a stand, use the Roland KS-G8, KS-18Z, or KS-12.
Place the instrument on the stand as follows.
KS-G8
Align the back panel
of the JUPITER-50
with the rubber base
of the stand.
Top view
Place the JUPITER-50 so
that its rubber feet are in
the inner side of the stand
KS-18Z
Align the front of the
JUPITER-50 with the
front of the stand
Adjust so that
the height does
not exceed 1
meter (Adjust
the stand to a
level no higher
than the fourth
level from the
bottom)
Adjust the width of the stand
so that the rubber feet of the
JUPITER-50 straddle the stand
Top view
KS-12
Adjust the width of the stand
so that the rubber feet on the
keyboard side of the bottom of
the keyboard t into the holes
provided for the rubber feet.
Top view
Placing the JUPITER-50 on a Stand