Roland Jupiter-50 - Initializing a Live Set; Copying a Layer

Editing a Live Set
63
Introduction Playing Sounds Editing Sounds
Other Convenient
Functions
Connecting Other
Equipment
Appendix
Quick Guide
Initializing a Live Set
Here’s how to initialize the currently selected Live Set.
MEMO
• Initializing the Live Set aects the data in the temporary area
(p. 24).
• If you want to return the parameters of all sounds to their
factory-set state, use Factory Reset (p. 79).
1. In the Menu screen (p. 35), choose “Initialize” “Live Set.”
A message will ask “Are you sure?”
2. Press the [F5] (OK) button
MEMO
In the LIVE SET (UPPER) screen (p. 36), you can also initialize the
Live Set by holding down the [SHIFT] button and pressing the
[F6] (INIT) button.
.
Copying a Layer
Here’s how to copy a layer to a dierent layer.
This is a convenient way to create a variation based on an edited
layer.
1. In the LIVE SET (UPPER) screen (p. 36), hold down the
[SHIFT] button and press the [F5] (COPY) button.
2. As the Source, specify the copy-source layer. As the
Destination, specify the copy-destination layer.
NOTE
When you copy a layer, the sound of the specied Destination
layer will be lost, and overwritten by the sound of the specied
Source layer.
3. Press the [F6] (EXEC) button.
A message will ask “Are you sure?”
4. Press the [F5] (OK) button.
The sound of the specied Source layer will be copied to the
specied Destination layer.