38
Switching Registrations
A Registration is used to store the sounds selected for each Part, as
well as various performance-related settings (system parameters
are excepted).
By switching Registrations, you can instantly change the song’s
sounds while you perform, or change numerous settings with a
single operation.
Here’s how to switch Registrations and verify that the settings have
been changed.
1. Press a Registration button ([1]–[4]) to select a
Registration.
The Registration will change.
MEMO
In the Top screen, you can also switch Registrations by moving
the cursor to the Registration number and using the value dial
or the [DEC] [INC] buttons.
Switching Banks
Each bank contains 4 Registrations. There are 4 banks, 1–4, meaning
that 4 Registrations x 4 banks = 16 Registrations are available.
Set 1
Registration
Bank
1
Registration
Bank
3
Registration
Bank
2
Registration
Bank
4
You can select other Registrations by switching banks.
1. Press the [BANK] button, and then press a registration
button ([1]–[4]) to select the desired bank.
The [BANK] button and the registration button corresponding to
the currently selected bank will light; the other buttons will blink.
When you switch banks, the registration buttons ([1]–[4]) will blink.
MEMO
If you decide to cancel without switching banks, press the [EXIT]
button or the lit bank button.
2. Press a Registration button ([1]–[4]) to select a
Registration.
The bank and Registration will be changed.
To Next Page
Loading...
