Roland Jupiter-50 - Basic Operations in the Audio Rec Standby Screen; Recording

Using the USB Memory Song Player/Recorder
68
Basic Operations in the Audio Rec Standby Screen
When you press the [REC] button, the Audio Rec Standby screen will appear.
Here you can make settings for recording.
RENAME
Renames the le in which
the recording will be saved.
[ ] (Play) button
Recording will begin.
Recording Mode
Recording
Mode
Explanation
MIX
Sound from the
keyboard, the USB
COMPUTER port, the
AUDIO IN jack, and the
playback from the USB
memory song player
will be recorded.
KEYBOARD
Sound from the
keyboard will be
recorded.
CNT IN (Count In)
Turn this on if you want a two-measure
count before recording.
Metronome Beat
Species the time signature
of the click sound.
CLICK
Switches on/o the click sound
during recording.
P.SYNC (Player Sync)
If this is on, audio le playback will begin at
the same moment that recording begins.
REC LEVEL Knob
/Level Meter
Use the Recording Level
knob to adjust the record-
ing level. Adjust it so the
“CLIP” indication does not
appear in the level meter.
FOLDER
Changes the folder in which
the recording will be saved.
Recording Folder/Recording File
Indicates the name of the folder and le
in which the recorded result will be saved.
Recording
Your keyboard performance can be recorded to a USB ash drive.
The audio being input via the JUPITER-50’s AUDIO IN jack and USB COMPUTER port can also be recorded.
NOTE
While the Audio Rec Standby screen is displayed, you must not
turn o the JUPITER-50’s power, or disconnect or connect your
USB ash drive.
Also, you must not turn o the JUPITER-50’s power or disconnect
or connect the USB ash drive while recording.
If you do so, the data might not be written correctly, or the
contents of memory might be destroyed.
1. Press the [REC] button.
The Audio Rec Standby screen will appear.
2. Make the recording settings, and then press the [ ]
(Play) button.
The [REC] button and [ ] (Play) button will light, and recording
will begin.
MEMO
• One minute of recorded data will occupy approximately 10 MB.
• To see how much free space remains on the USB ash drive,
refer to “INFORMATION” (p. 78).
3. To stop recording, press the [ ] (STOP) button.
Recording will stop, and the recorded result will be saved on the
USB ash drive.
Audio les that will be saved
WAV
Sampling Frequency 44.1 kHz
Bit Rate 16-bit