Roland Jupiter-50 - Restoring the Factory Settings (Factory Reset); Making the Power Automatically Turn Off After a Time (Auto Off)

The JUPITER-50’s System Settings
79
Introduction Playing Sounds Editing Sounds
Other Convenient
Functions
Connecting Other
Equipment
Appendix
Quick Guide
Restoring the Factory Settings
(Factory Reset)
This “Factory Reset” operation will restore all settings of the
JUPITER-50 to their factory-set state.
NOTE
When you execute the Factory Reset operation, all data in the
JUPITER-50 will be lost. If there is any data that you want to
keep, back it up to a USB ash drive (p. 70).
1. In the Menu screen (p. 35), choose “Utility” and press the
[ENTER] button.
The UTILITY MENU screen will appear.
2. Choose "Factory Reset" and press the [ENTER] button.
A message will ask “Are you sure?”
3. To execute the factory reset, press [F5] (OK) button.
NOTE
The factory reset operation will take several minutes. Never turn
o the power before the factory reset has been completed.
When the factory reset has been completed, the screen will indicate
“Completed. Please Power O.”
4. Turn the power o, and then on again.
Making the Power Automatically
Turn O After a Time (Auto O)
With the factory settings, the JUPITER-50’s power will automatically
be switched o 4 hours after you stop playing or operating the unit.
If you don’t need the power to turn o automatically, set “Auto O”
to the “OFF” setting as described below.
1. In the Menu screen (p. 35), choose “System” and press the
[ENTER] button.
The SYSTEM MENU screen will appear.
2. Choose "Setup” and press the [ENTER] button.
The SYSTEM SETUP screen will appear.
3. Press the [F6] (MISC) button.
4. Use the cursor buttons to choose “Auto o,” and change
the setting.
Value Explanation
OFF The power will not turn o automatically.
30 [min]
The power will automatically turn o if no operation is
performed for 30 minutes.
240
[min]
(default)
The power will automatically turn o if no operation is
performed for 240 minutes (4 hours).
5. Press the [WRITE] button.
The screen will ask “Are you sure?”
6. Press the [F5] (OK) button.
A message will indicate “Completed!” and the settings will be saved.
NOTE
• Never turn o the power while data is being saved.
• When turning the unit’s power back on after it has been shut
down due to the Auto O function, always make sure to allow
at least ten seconds to pass after the power has been shut o
before you turn the power back on. If you turn it back on too
rapidly, the Auto O function will not have had enough time to
reset itself, and you may not be able to turn on the power in the
normal way.