Roland Jupiter-50 - Using the Buttons and Knobs to Modify the Sound ([S1] [S2] buttons; [C1] [C2] knobs); Using Pedals

Controlling the Performance
52
Using the Buttons and Knobs to Modify the
Sound ([S1] [S2] buttons / [C1] [C2] knobs)
Performance-related functions are assigned to the [S1] [S2] buttons
and [CUTOFF/C1] [RESONANCE/C2] knobs. While you perform, you
can operate the [S1] [S2] buttons or [CUTOFF/C1] [RESONANCE/C2]
knobs to modify the sound in real time.
Turning the [S1] [S2] buttons on/o will turn on/o or switch the
assigned function.
MEMO
You can assign performance-related functions to the [S1] [S2]
buttons.
To assign functions to the [S1] [S2] buttons, go to the
REGISTRATION CONTROL screen (p. 54), choose [F5] (S1/S2), and
set Switch S1 Assign or Switch S2 Assign to the desired function.
Operating the [CUTOFF/C1] [RESONANCE/C2] knobs will control the
function assigned to each knob.
MEMO
You can assign performance-related functions to the [CUTOFF/
C1] [RESONANCE/C2] knobs.
To assign functions to the [CUTOFF/C1] [RESONANCE/C2] knobs,
go to the REGISTRATION CONTROL screen (p. 54), choose [F4]
(knob), and set knob1 Assign or knob2 Assign to the desired
function.
Using Pedals
The JUPITER-50 allows you to connect hold pedals (such as one
from the DP series; sold separately) and expression pedals (EV-5;
sold separately).
If a hold pedal (such as one from the DP series; sold separately)
is connected to the rear panel PEDAL HOLD jack, notes will be
sustained (held) while you hold down the pedal even after you take
your hands o the keyboard.
If an expression pedal or pedal switch (EV-5, DP series unit; sold
separately) is connected to the rear panel CTRL 1 or CTRL 2 jack,
you can use the pedal to vary the volume or control a variety of
functions.
Sustaining the Notes (Hold Pedal)
While playing the keyboard, step on the pedal switch.
You can hold (sustain) the notes by stepping on the pedal switch.
Adding Expression to Your Performance
(Control Pedal)
While playing the keyboard, raise or lower the expression pedal.
You can make your performance more expressive by varying the
volume.
* You must use the specied expression pedal (EV-5; sold
separately). Connecting a product made by another
manufacturer may cause the JUPITER-50 to malfunction.
MEMO
Performance-related functions can be assigned to the pedals
connected to the CTRL 1 and CTRL 2 jacks. The CTRL 1 and
CTRL 2 assignments are specied by the ”System Setup” (p. 75)
parameters Pedal 1 Assign and Pedal 2 Assign.