Roland Jupiter-50 - Specifying the Transmit Channel; Specifying the Sound for Each Channel; Detailed Settings for External Parts

Connecting an External MIDI Device
82
Specifying the Transmit Channel
Set the JUPITER-50’s transmit channel so it matches the channel
your external MIDI device is using for reception.
1. In the REGISTRATION EXT PART screen, select the “KB”
check box of the channel on which you want to transmit,
and use the value dial to turn it on.
When you play the keyboard, performance data will be transmitted
from the MIDI OUT connector on the channel you specied.
MEMO
For details on how to set the receive channel of your external
MIDI device, refer to its owner’s manual.
Specifying the Sound for Each Channel
To switch the tones of an external MIDI device, the program
number and the MSB/LSB of the Bank Select message are entered
as numerical values on the JUPITER-50.
1. Specify the program change and bank select MSB/LSB for
the channel whose “KB” check box you turned on in the
REGISTRATION EXT PART screen.
MEMO
• When this setting is “- - -,” bank select and program change
messages will not be transmitted.
• If the external MIDI sound module receives a Program number
or a Bank number for which no Tone has been assigned, an
alternate Tone may be selected, or in some cases, there may be
no sound played.
Detailed Settings for External Parts
Here you can make detailed settings for the messages transmitted
to an external MIDI device.
Parameter Value Explanation
KB
(Keyboard)
OFF, ON
Species whether the perfor-
mance data of the External Part
will be transmitted.
MSB
(Bank Select
MSB)
0–127, ---
* Not transmitted for
Parts whose KB is o.
Species the MSB (controller
number 0) of the bank select
number transmitted when you
switch Registrations.
Choose “---” if you don’t want
this to be transmitted.
LSB
(Bank Select
LSB)
0–127, ---
* Not transmitted for
Parts whose KB is o.
Species the LSB (controller
number 32) of the bank select
number transmitted when you
switch Registrations.
Choose “---” if you don’t want
this to be transmitted.
PC
(Program
Change)
1–128, ---
* Not transmitted for
Parts whose KB is o.
Species the program change
number transmitted when you
switch Registrations.
Choose “---” if you don’t want
this to be transmitted.
OCT
(Octave Shift)
-3–+3
* This parameter is valid
only for Parts whose
KB is on.
Species the octave shift.
KL
(Key Range
Lower)
C- –(KU)
* This parameter is valid
only for Parts whose
KB is on.
Species the lowest key of the
range that will sound.
KU
(Key Range
Upper)
(KL)–G9
* This parameter is valid
only for Parts whose
KB is on.
Species the highest key of the
range that will sound.
VL
(Velocity
Range Lower)
1–(VU)
* This parameter is valid
only for Parts whose
KB is on.
Species the lowest velocity
value.
VU
(Velocity
Range Upper)
(VL)–127
* This parameter is valid
only for Parts whose
KB is on.
Species the highest velocity
value.
LVL
(Level)
0–127, ---
* Not transmitted for
Parts whose KB is o.
Species the volume message
transmitted when you switch
Registrations.
Choose “---” if you don’t want
this to be transmitted.
PAN
(Pan)
L64–0–63R, ---
* Not transmitted for
Parts whose KB is o.
Species the pan message
transmitted when you switch
Registrations.
Choose “---” if you don’t want
this to be transmitted.