Roland Jupiter-50 - Using the USB Memory Song Player;Recorder; Basic Operations in the SONG Screen; Playback

64
Using the USB Memory Song Player/Recorder
The USB Memory Song Player/Recorder lets you
play back audio les (WAV, MP3, AIFF) that you’ve
copied from your computer to a USB ash drive,
or to record your keyboard performance to a USB
ash drive.
NOTE
• Never insert or remove a USB ash drive while this unit’s power
is on. Doing so may corrupt the unit’s data or the data on the
USB ash drive.
• Carefully insert the USB ash drive all the way in-until it is rmly
in place.
• Use USB ash drive available from Roland. Proper operation
cannot be guaranteed if other USB device is used.
• Don’t connect anything other than a USB ash drive to the USB
MEMORY connector.
MEMO
If the USB ash drive contains a large number of song les, it
may take some time for them to be read.
Basic Operations in the SONG Screen
When you press the [SONG] button, the SONG LIST screen or the
SONG SETUP screen will appear.
Use the [F1] (LIST) button and [F2] (SETUP) button to switch
between screens.
In the SONG LIST screen you can select an audio le to playback.
In the SONG SETUP screen you can make settings for playback.
Audio les are listed
here.
Indicates the current time
of the audio le.
Adjust the volume
of the song player.
Set the playback
speed (p. 65).
Set the playback
pitch (p. 65).
Turn chain play on/
o (p. 66).
Assign the cur-
rently playing (or
stopped) location
as the start of loop
playback.
Turn loop play on/
o (p. 65).
Assign the cur-
rently playing (or
stopped) location
as the end of loop
playback.
MEMO
Copy your audio les (WAV, MP3, AIFF) to the root folder (the top
level) of your USB ash drive, or create a folder on your USB ash
drive and copy the les into it. For more about folders in USB
ash drive, refer to “USB Flash Drive” (p. 25).
Playback
Here’s how to play back audio les saved on the USB ash drive.
1. Press the [SONG] button.
The SONG LIST screen will appear. A list of the audio les on the
USB ash drive will appear.
If the SONG SETUP screen is displayed, press the [F1] (LIST) button
to access the SONG LIST screen.
MEMO
If the le name or folder name contains double-byte characters
(e.g., Japanese), they will not be shown correctly in the display.
2. Use the value dial or the [DEC] [INC] buttons to select an
audio le.
MEMO
• To view les that are inside a folder, select that folder and press
the [
] (cursor) or [ENTER] button.
• The folder you’re currently viewing is shown at the top of the
list. To return to the next higher level folder, press the [
]
(cursor) button.
Currently shown folder
Folder
3. Press the [ ] (PLAY) button.
The selected audio le will play.
• Press the [
] (STOP) button to stop playback.
When you press the [ ] (PLAY) button once again, playback
will resume from where it was stopped.
• Press the [
] button to return to the beginning of the audio
le.
• Rewinds the audio le while you hold down the [
] button.
• Fast-forwards the audio le while you hold down the [
]
button.