Roland Jupiter-50 - Changing a Live Set’s Tones; Layer On;Off and Volume Adjustment; Switching the MFX (Multi-effects)

Editing a Live Set
58
Changing a Live Set’s Tones
Here’s how to change the Tones in a Live Set.
1. In the LIVE SET (UPPER) screen (p. 36), move the cursor to
the tone name and press the [ENTER] button.
The TONE LIST screen will appear.
2. Select the new tone, and then press the [ENTER] button.
The tone category is shown at the top of the list of tones.
The Tone will change.
MEMO
The SuperNATURAL Acoustic Tone 0028: TW Organ can be
assigned only to layer 1.
Layer On/O and Volume Adjustment
Here’s how to turn each layer on/o or adjust its volume.
1. In the LIVE SET (UPPER) screen (p. 36), hold down the
[SHIFT] button and press a button from [F1] (LAYER 1)
through [F4] (LAYER 4).
Layer Status
OFF
ON
By holding down the [SHIFT] button while you press one of the
[F1]–[F4] buttons, you can turn the corresponding layer on/o.
MEMO
Alternatively, you can move the cursor to a layer that you want
to change, and use the value dial to turn that layer on/o.
2. Move the cursor to a slider and adjust the volume.
Switching the MFX (Multi-eects)
Each Live Set contains four MFX (multi-eects) processors.
The “LIVE SET EFFECTS screen” is used to switch MFX settings.
1. In the LIVE SET (UPPER) screen (p. 36), press the [F3]
(EFFECT) button.
2. Move the cursor to the MFX processor that you want to
change, and use the value dial to change the eect type.
Turning MFX On/O
1. In the LIVE SET (UPPER) screen (p. 36), press the [F3]
(EFFECT) button.
2. Press the [F6] (SWITCH) button.
The EFFECT SWITCH window will appear.
3. Use the [F1] (MFX 1)–[F5] (REVERB) buttons to turn each
eect on/o.
The eect will turn on/o each time you press the corresponding
button.
4. To close the edit window, press the [F6] (CLOSE) button or
the [EXIT] button.
You’ll be returned to the LIVE SET EFFECTS screen.