Roland Jupiter-50 - Controlling the Rotary Effect and Reverb; Controlling the Rotary Effect; Controlling Reverb

53
Introduction Playing Sounds Editing Sounds
Other Convenient
Functions
Connecting Other
Equipment
Appendix
Quick Guide
Controlling the Rotary Eect and Reverb
The rotary eect adds modulation similar to what is produced by
rotary speakers to the sound. Reverb applies the reverberation
that accompanies a sound played in a hall or other acoustic
environment.
You can control these eects by using panel buttons.
Controlling the Rotary Eect
The ROTARY SOUND [ON/OFF] button and [SLOW/FAST] button
allow you to control the eect if a rotary eect is assigned to MFX of
the Live Set.
1. First, assign 21: Rotary or 22: VK-Rotary to the MFX of the
Live Set (p. 58).
2. Press the ROTARY SOUND [ON/OFF] button.
The rotary eect will turn on (the button will light).
3. Press the ROTARY SOUND [SLOW/FAST] button.
The speed of the rotary eect will change.
The rotary eect can be switched between two settings: “SLOW”
and “FAST.”
ROTARY SOUND
[SLOW/FAST]
button
Explanation
Unlit (SLOW)
The eect produced when the rotary speaker is
turning slowly.
Lit (FAST)
The eect produced when the rotary speaker is
turning rapidly.
When you switch the rotary eect from “SLOW” to “FAST,” the
modulation speed will increase; when you switch from “FAST” to
“SLOW,” the modulation speed will decrease.
Controlling Reverb
The [REVERB] button simultaneously turns on/o the output of
the Live Set’s reverb and of the reverb shared by the Solo and
Percussion Parts.
If you want reverb to always be o, turn o the [REVERB] button.
The illustration below shows how the [REVERB] button works.
REVERB
[ON/OFF]
Solo Part
Upper Part
Percussion/
Lower Part
Registration
Live set
Tone
Tone
Reverb
MEMO
The state of the [REVERB] button is not saved. It will
automatically turn on when you turn on the power.