Roland Jupiter-50 - Saving a Registration

Editing a Registration
55
Introduction Playing Sounds Editing Sounds
Other Convenient
Functions
Connecting Other
Equipment
Appendix
Quick Guide
Saving a Registration
Edits you make to a Registration are temporary; they will be lost
when you turn o the power or select another Registration. If you
want to keep an edited Registration, you must save it.
NOTE
When you execute the Write operation, the existing data at the
write destination will be overwritten.
REFERENCE
For details on how a Registration is structured, refer to “How
Registrations are Organized” (p. 23).
1. In the REGISTRATION screen (p. 36), press the [WRITE]
button.
The REGISTRATION WRITE screen will appear. The [WRITE] button
will light, and the Registration buttons will blink.
2. Move the cursor to the position shown in the illustration,
and select the write destination.
Registration number
MEMO
You can also use the Registration buttons ([1]–[4]) to directly
specify the write destination.
3. Press the [F6] (WRITE) button.
A message will ask “Are you sure?”
4. To write the data, press the [F5] (OK) button.
The message “Completed!” will appear.
The Registration has been saved.
NOTE
Never turn o the power while data is being saved.
Cancelling the Save of a Registration
You can cancel the save operation by doing one of the following.
• Press the [EXIT] button
• Press the [WRITE] button
Naming a Registration
If you want to rename the Registration, press the [F5]
(RENAME) button of step 2.
The REGISTRATION NAME screen will appear.
For details on assigning a name, refer to “Assigning a Name”
(p. 34).
If the following display appears when you save
If Live Set parameters have been edited, the check box on left of
the Live Set name will be marked automatically when you save the
Registration.
The Live Set has been edited.
You have the option of saving the edited Live Set at the same time
that you save the Registration.
MEMO
If you save without selecting this check box, only the
Registration will be saved. The Live Sets you’ve edited will
remain in their edited state without being saved.
1. If you want to save to a specied Live Set number, move
the cursor to the position shown in the illustration and
select the desired number.
If you want to overwrite the current Live Set, proceed to the next
step without changing the writing destination.
2. Press the [F6] (WRITE) button.
A message will ask “Are you sure?”
3. To write the data, press the [F5] (OK) button.
The message “Completed!” will appear.