Roland V-Synth GT - Audio Input

200
System Mode (Settings Common to All Modes)
fig.08-03.eps_50
Audio Input
Parameter
Value Description
Mic Sw (MIC Jack Switch)
ON, OFF
Specifies whether the rear panel MIC IN jack will be enabled (ON) or dis-
abled (OFF).
Peak This will light when the input volume is excessive.
Level Indicates the input volume.
Input Gain (INPUT Jack Gain) 0dB, +10dB
Sets the gain of the rear panel INPUT jacks.
Input Sw (INPUT Jack Switch) ON, OFF
Specifies whether the rear panel INPUT jacks will be enabled (ON) or dis-
abled (OFF).
Ext In Source
(External Input Source)
Selects the source of external in-
put used when Oscillator Type (p.
95) is set to “EXT IN.”
ANALOG The MIC IN jack or INPUT jacks will be the input source.
USB The USB audio from a computer connected to the V-Synth GT will be the input
source.
Ext In Type
(External Input Type)
Selects the type of external input
used when Oscillator Type (p. 95)
is set to “EXT IN.”
STEREO Inputs in stereo.
MONO-L+R Mixes the L and R input signals and inputs in monaural.
MONO-L Inputs the L signal in monaural.
MONO-R Inputs the R signal in monaural.
V-Synth-GT_e.book 200 ページ ２００７年４月９日 月曜日 午後１時４６分