68
Patch Mode (Editing a Patch)
Here you can specify the zones of the keyboard in which the upper and lower tones are to be sounded.
You can also specify how the two tones will be played.
You can access this screen not only from the Patch Common screen, but also directly by touching <Key Range> in the
Patch Menu.
fig.05-30-j.eps_50
Key Range
Parameter
Value Description
Key Range Upper/Lower
Min
C-1–G9
Specify the lowest keys of the ranges within which the upper tone or lower tone
will be sounded.
Max
C-1–G9
Specify the highest keys of the ranges within which the upper tone or lower tone
will be sounded.
Single Sw (Single Switch)
Only the upper tone will play across the entire keyboard.
Dual Sw (Dual Switch)
The upper tone and lower tone will both play across the entire keyboard.
Split Sw (Split Switch)
The upper tone and lower tone will be split and will sound in separate zones of
the keyboard.
If you hold down a note of the keyboard and touch Split Sw, the keyboard will
be split at that note.
If you touch Split Sw without holding down a note, the keyboard will be split at
C4.
From this screen you can turn the lower
and upper tones on/off and make other
changes for the tones.
V-Synth-GT_e.book 68 ページ ２００７年４月９日 月曜日 午後１時４６分
To Next Page
Loading...
Need help?
General
