225
Utility Mode
Backing Up Patch and Wave Data (Project) from the V-Synth GT
When using USB in Storage function, the data within the V-Synth GT may be damaged if you operate your computer
incorrectly or if your computer crashes. As a precaution against such occurrences, we recommend that you create a
backup as described below.
Backing Up the V-Synth GT’s Internal Data onto Your Computer
1.
Use a USB cable to connect the V-Synth GT to your computer as described in “Connecting the V-Synth GT to your
computer” (p. 221, p. 223).
2.
Using your computer, copy the V-Synth GT’s
files and
folders onto a drive (e.g., hard disk) of your computer.
3.
Cancel the USB connection (p. 222, p. 224).
Loading Backup Data from Your Computer into the V-Synth GT
1.
Use a USB cable to connect the V-Synth GT to your computer as described in “Connecting the V-Synth GT to your
computer” (p. 221, p. 223).
2.
Using your computer, copy the
files and
folders that you previously saved on your computer to the V-Synth GT.
3.
Cancel the USB connection (p. 222, p. 224).
Examples of Using Storage Function
Note when connecting the V-Synth GT to your computer
Do not format, optimize, or execute the scan disk command on the V-Synth GT’s user memory from your computer.
V-Synth-GT_e.book 225 ページ ２００７年４月９日 月曜日 午後１時４６分
To Next Page
Loading...
