Roland V-Synth GT - Patch Mode (Editing a Patch); Creating a Patch

54
Patch Mode (Editing a Patch)
With the V-Synth GT, you have total control over a wide variety of settings.
This chapter explains the procedures used in creating patches, and the functions of the patch parameters.
1.
Access the Patch Play screen, and select the patch that you want to edit (p. 40).
If you want to create all your patches from the ground up, rather than the patches that have already been prepared,
carry out the Initialize operation (p. 62).
2.
Select the tones that you want to use for the upper tone and lower tone (p. 55).
3. Apply effects (chorus and reverb) (p. 76).
4. Save the patch (p. 58).
When you carry out a save, any data previously stored at the save destination will be overwritten and lost.
Creating a Patch
V-Synth-GT_e.book 54 ページ ２００７年４月９日 月曜日 午後１時４６分