Roland V-Synth GT - Adjusting the Positional Accuracy of the Time Trip Pad

232
Utility Mode
Perform this adjustment if the Time Trip pad no longer responds as you expect.
1.
In the Utility Menu screen, touch <Calibration>.
The Calibration screen appears.
fig.09-30-ps.eps_50
2.
Touch <Time Trip Pad>.
The TT Pad Calibration screen appears.
fig.09-32-ps.eps_50
3.
On the Time Trip pad, touch the points indicated by the square symbol in the screen, in the following order: left
→ top → right → bottom.
When you have touched all four points, the screen will close, and the sensitivity of the Time Trip pad will be
calibrated.
fig.09-38.eps_50
Adjusting the Positional Accuracy of the Time Trip Pad
V-Synth-GT_e.book 232 ページ ２００７年４月９日 月曜日 午後１時４６分