Roland V-Synth GT - D Beam; S1;S2 Switch

67
Patch Mode (Editing a Patch)
fig.05-22.eps_50
fig.05-24.eps_50
D Beam
Parameter
Value Description
D Beam (D Beam Mode)
OFF
The D Beam controller will not be used.
Time Trip The D Beam controller will control the Time Trip effect (p. 46).
Time The D Beam controller will control the Time Control effect.
Pitch The D Beam controller will control the Pitch Control effect.
Assignable The D Beam controller will control the effect specified for each tone.
For details on how to specify the effect that will be controlled when
“Assignable” is selected, refer to “Matrix Control” (p. 91).
S1/S2 Switch
Parameter
Value Description
S1/S2 Switch Setting
Latch
The on/off status will alternate each time you press [S1] [S2].
Momentary The status will be on only while you hold down [S1] [S2].
V-Synth-GT_e.book 67 ページ ２００７年４月９日 月曜日 午後１時４６分