73
Patch Mode (Editing a Patch)
Creating a Pattern by Playing in Real Time (Real Rec)
This method lets you create a pattern in a way similar to realtime recording on a sequencer. Your playing on the V-
Synth GT’s keyboard and your controller operations will be recorded “as is.”
1.
Specify the Grid and End Point of the arpeggio pattern that you will be creating.
Move the cursor to each value box and set the value.
2.
Touch <Real Rec>.
The V-Synth GT will be in realtime-input standby mode, and the metronome will sound a guide rhythm.
fig.02-09c_50
3.
If you want to adjust the tempo, turn ARPEGGIO [TEMPO].
Turn the knob toward the right to make the tempo faster, or toward the left to make it slower.
4.
In time with the guide rhythm sounded by the metronome, play the V-Synth GT’s keyboard and operate the
controllers.
You can repeatedly record over the pattern length (number of steps) you specified in step 1. On each pass, you
can add new notes and control changes to build up the pattern.
The notes (specified pitches) and control changes in a single pattern cannot exceed a total of 16. All further
(seventeenth and later) notes having a new pitch or control changes will not be recorded.
5.
When you are finished with realtime input, touch <Stop>.
The metronome guide will stop sounding.
6.
Press ARPEGGIO [ON/OFF] to turn on the arpeggiator, and play the keyboard to hear your realtime-recorded
pattern.
V-Synth-GT_e.book 73 ページ ２００７年４月９日 月曜日 午後１時４６分
To Next Page
Loading...
Need help?
General
